Legend Tuned · ECU Software

Motorcycle

Honda Powersports CRF250L (2012–2016) 249 cc 23 HP ECU Software & Chip Tuning

  • 2012–2016
  • Petrol
  • 23 HP · 22 Nm

Target with Legend Tuned Stage 1: 25 HP / 23 Nm; with Stage 2: 26 HP / 24 Nm. The original software is backed up, the calibration is tailored to the car, and the result is verified by datalog.

Legend Tuned figures

Stage 1
Power +2 HP +9%
25 HP Stock 23 HP · 17 → 18 kW
Stock
23 HP
Stage 1
25 HP
Torque +1 Nm +5%
23 Nm Stock 22 Nm
Stock
22 Nm
Stage 1
23 Nm

Figures are examples/estimates and may vary with the car's mileage, maintenance condition, fuel quality and hardware. Exact results are determined by dyno/datalog.

Power & torque curve

Stock vs Stage comparison

A representative power and torque curve with a technical table of all figures. Hover over the chart to see values by rpm.

Technical figures

Honda Powersports CRF250L (2012–2016) 249 cc 23 HP — stock and Stage figures
Value Stock Stage 1 Stage 2
Power23 HP25 HP26 HP
Power (kW)17 kW18 kW19 kW
Torque22 Nm23 Nm24 Nm
Power gain—+2 HP (+9%)+3 HP (+13%)
Torque gain—+1 Nm (+5%)+2 Nm (+9%)
Vehicle
Honda Powersports CRF250L (2012–2016)
Type
Motorcycle
Engines
249 cc
Years
2012–2016
Fuel
Petrol

Figures are examples/estimates and may vary with the car's mileage, maintenance condition, fuel quality and hardware. Exact results are determined by dyno/datalog.

Custom software · 5 options

Custom software options for this engine

Legend Tuned functions suitable for this engine, which can be applied in the same session as Stage software or on their own.

Stage 2 hardware, peace of mind and process

Stage 2 requirements

Stage 2 ready with exhaust and air filter

At Stage 2, the engine's breathing is freed up with hardware: the exhaust and air filter are upgraded, and the software is written to match that hardware. The target for this engine is 26 HP / 24 Nm.

  • Exhaust systemA slip-on or full exhaust system; the software is written for the exhaust fitted.
  • Air filterA high-flow sport air filter; the airbox inlet is modified if needed.
  • Datalog & fine-tuningAir/fuel ratio and ignition are logged during a road or off-road test; fine-tuning is done if needed.
  • Health checkIgnition, fuel system, clutch / CVT belt and cooling checked for this power level; the job takes ~4–8 hours (depending on parts fitted).

Included every time

Power with peace of mind

  • Original software backup — the factory software is read and archived before the job.
  • Reversal — the car can be returned to its original software whenever you ask.
  • Datalog check — ignition, air/fuel ratio and engine temperature are recorded and checked during a road or off-road test.
  • Vehicle-specific calibration — not an off-the-shelf file; tuned to the engine, hardware and fuel quality.
  • Pre-tune diagnostics — fault memory is read and engine health is checked before the software.
  1. Book

    Tell us about your car and your goals; we'll plan the day and time together.

  2. Analysis & backup

    Fault memory is read, the ECU is identified and the original software is archived.

  3. Legend Tuned software

    Calibration tailored to the car (Stage 1: ~1–2 hours).

  4. Test & handover

    Verified with a road test + datalog, then handed over with a walkthrough of what was done.

Honda Powersports CRF250L (2012–2016)

Other engines in the same generation

All engines table

No other engines are listed for this generation.

Other CRF250L generations

Vehicle Selector

Choose another vehicle

Start by selecting a make.

Stage 1 25 HP +2
Book an appointment