Legend Tuned · Chip Tuning

SEAT Leon 3 (5F) 1.6 TDI 90 HP Chip Tuning

  • 2012–2017
  • Diesel
  • 90 HP · 230 Nm
  • ECU: Delphi DCM6.2

Target with Legend Tuned Stage 1: 150 HP / 320 Nm. The original software is backed up, the calibration is tailored to the car, and the result is verified by datalog.

Legend Tuned figures

Stage 1
Power +60 HP +67%
150 HP Stock 90 HP · 66 → 110 kW
Stock
90 HP
Stage 1
150 HP
Torque +90 Nm +39%
320 Nm Stock 230 Nm
Stock
230 Nm
Stage 1
320 Nm

Figures are examples/estimates and may vary with the car's mileage, maintenance condition, fuel quality and hardware. Exact results are determined by dyno/datalog.

Power & torque curve

Stock vs Stage 1 comparison

A representative power and torque curve with a technical table of all figures. Hover over the chart to see values by rpm.

Technical figures

SEAT Leon 3 (5F) 1.6 TDI 90 HP — stock and Stage figures
Value Stock Stage 1
Power90 HP150 HP
Power (kW)66 kW110 kW
Torque230 Nm320 Nm
Power gain—+60 HP (+67%)
Torque gain—+90 Nm (+39%)
Vehicle
SEAT Leon 3 (5F)
Engines
1.6 TDI
Years
2012–2017
Fuel
Diesel
ECU
Delphi DCM6.2
Stage 2
Not listed for this engine

Figures are examples/estimates and may vary with the car's mileage, maintenance condition, fuel quality and hardware. Exact results are determined by dyno/datalog.

Custom software · 5 options

Custom software options for this engine

Legend Tuned functions suitable for this engine, which can be applied in the same session as Stage software or on their own.

Stage 2 hardware, peace of mind and process

After Stage 1

Stage 2 is not listed for this engine

There's no meaningful Stage 2 figure for this engine; most of the gain comes with Stage 1 software. For livelier throttle response and a deeper intake sound, you can complement Stage 1 with the Custom Sport Filter Kit.

Included every time

Power with peace of mind

  • Original software backup — the factory software is read and archived before the job.
  • Reversal — the car can be returned to its original software whenever you ask.
  • Datalog check — boost pressure, ignition and air/fuel ratio are recorded and checked on a road test.
  • Vehicle-specific calibration — not an off-the-shelf file; tuned to the engine, hardware and fuel quality.
  • Pre-tune diagnostics — fault memory is read and engine health is checked before the software.
  1. Book

    Tell us about your car and your goals; we'll plan the day and time together.

  2. Analysis & backup

    Fault memory is read, the ECU is identified and the original software is archived.

  3. Legend Tuned software

    Calibration tailored to the car (Stage 1: ~1–2 hours).

  4. Test & handover

    Verified with a road test + datalog, then handed over with a walkthrough of what was done.

SEAT Leon 3 (5F)

Other engines in the same generation

All engines table

Other Leon generations

Vehicle Selector

Choose another vehicle

Start by selecting a make.

Stage 1 150 HP +60
Book an appointment